How would you Confirm on R1 That Load Balancing is Actually Occurring on the Default-Network (0.0.0.0)?
How would you confirm on R1 that load balancing is actually occurring on the default-network
(0.0.0.0)?
A.Use ping and the show ip route command to confirm the timers for each default network resets to 0.
B.Load balancing does not occur over default networks; the second route will only be used for failover.
C.Use an extended ping along with repeated show ip route commands to confirm the gateway of last resort address toggles back and forth.
D.Use the traceroute command to an address that is not explicitly in the routing table.
Answer:D
PC2 in VLAN 200 is unable to ping the gateway address 172.16.200.1; identify the issue.
A customer network engineer has made configuration changes that have resulted in some loss of connectivity. You have been called in to evaluate a switch network and suggest resolutions to the problems.
PC2 in VLAN 200 is unable to ping the gateway address 172.16.200.1; identify the issue.
A.VTP domain name mismatch on SW4
B.VLAN 200 not configured on SW1
C.VLAN 200 not configured on SW2
D.VLAN 200 not configured on SW4
Answer D
Explanation:
By looking at the configuration for SW2, we see that it is missing VLAN 200, and the “switchportaccess vlan 200” command is missing under interface eth 0/0:
